[OK] -9o{vmB{
Restricted Rights Legend -9o{vmB{
Use, duplication, or disclosure by the Government is -9o{vmB{
subject to restrictions as set forth in subparagraph -9o{vmB{
(c) of the Commercial Computer Software - Restricted -9o{vmB{
Rights clause at FAR sec. 52.227-19 and subparagraph -9o{vmB{
(c) (1) (ii) of the Rights in Technical Data and Computer -9o{vmB{
Software clause at DFARS sec. 252.227-7013. z ,P:i$
cisco Systems, Inc. z ,P:i$
170 West Tasman Drive z ,P:i$
San Jose, California 95134-1706 z ,P:i$
Cisco Internetwork Operating System Software z ,P:i$
IOS (tm) 3600 Software (C3640-I-M), Version 12.1(2)T, RELEASE SOFTWARE (fc1) z ,P:i$
Copyright (c) 1986-2000 by cisco Systems, Inc. z ,P:i$
Compiled Tue 16-May-00 12:26 by ccai z ,P:i$
Image text-base: 0x600088F0, data-base: 0x60924000 z ,P:i$
cisco 3640 (R4700) processor (revision 0x00) with 24576K/8192K bytes of memory. z ,P:i$
Processor board ID 25125768 z ,P:i$
R4700 CPU at 100Mhz, Implementation 33, Rev 1.0 z ,P:i$
Bridging software. z ,P:i$
X.25 software, Version 3.0.0. z ,P:i$
2 FastEthernet/IEEE 802.3 interface(s) z ,P:i$
1 Serial network interface(s) z ,P:i$
DRAM configuration is 64 bits wide with parity disabled. z ,P:i$
125K bytes of non-volatile configuration memory. z ,P:i$
8192K bytes of processor board System flash (Read/Write) z ,P:i$
--- System Configuration Dialog --- z ,P:i$
Would you like to enter the initial configuration dialog? [yes/no]: y z ,P:i$
您是否进入初始化配置对话,选Y z ,P:i$
At any point you may enter a question mark '?' for help. z ,P:i$
Use ctrl-c to abort configuration dialog at any prompt. z ,P:i$
Default settings are in square brackets '[]'.Basic management setup configures only enough connectivity z ,P:i$
for management of the system, extended setup will ask you z ,P:i$
to configure each interface on the system z ,P:i$
Would you like to enter basic management setup? [yes/no]: n z ,P:i$
您是否进入基本配置安装,选N z ,P:i$
First, would you like to see the current interface summary? [yes]: y z ,P:i$
首先,您是否看一下当前端口状态 z ,P:i$
Any interface listed with OK? value "NO" does not have a valid configuration z ,P:i$
Interface IP-Address OK? Method Status Protocol z ,P:i$
FastEthernet0/0unassigned NO unset up down z ,P:i$
Serial0/0 unassigned NO unset down down z ,P:i$
FastEthernet0/1unassigned NO unset up down z ,P:i$
Configuring global parameters: z ,P:i$
Enter host name [Router]:RouterA z ,P:i$
输入路由器的名字 z ,P:i$
The enable secret is a password used to protect access to z ,P:i$
privileged EXEC and configuration modes. This password, after z ,P:i$
entered, becomes encrypted in the configuration. z ,P:i$
Enter enable secret: aaa z ,P:i$
输入密文 z ,P:i$
The enable password is used when you do not specify an z ,P:i$
enable secret password, with some older software versions, and z ,P:i$
some boot images. z ,P:i$
Enter enable password: bbb z ,P:i$
输入密码(不能和密文相同) z ,P:i$
The virtual terminal password is used to protect z ,P:i$
access to the router over a network interface. z ,P:i$
Enter virtual terminal password: ccc z ,P:i$
输入虚拟终端的密码(以备远程登录) z ,P:i$
Configure SNMP Network Management? [yes]: n z ,P:i$
配置简单网管吗?选N z ,P:i$
Configure IP? [yes]: y z ,P:i$
配置IP吗?选Y z ,P:i$
Configure IGRP routing? [yes]: n z ,P:i$